Stanton SA.3 owner manual M O V I N G Fa C E P L At E, E a N I N G FA D E R S

Page 9

R E M O V I N G FA C E P L AT E

1 . Unplug the power supply from the back of the mixer. Verify that the mixer is pow - ered off .

2 . Remove the 4 screws on the face - plate . Place the 4 screws somewhere safe where they will not be lost .

3 . Remove the 3 fader knobs from the line faders and crossfader.

4 . The faceplate can now be removed from the top of the mixer.

2

3

2

(BACKPANEL VIEW)

2

3

3

2

C L E A N I N G FA D E R S

1 . Make sure the mixer is powered off . Remove the faceplate of the mixer by following the directions above .

2 . Remove the fader from the mixer by unscrewing the two outer screws on the fader plate . Do not remove the two inside screws on the fader plate; this will remove the fader from the fader plate .

3 . Once fader has been removed from mixer, spray a small amount of contact cleaner into the fader and move the fader back and forth to disperse the cleaner.

Image 9

Contents SA.3 L C O M E E a S E R E a D C a R E F U L LY B E F O R E U S E SA Features TOP Panel Description of FunctionsX E R F U N C T I O N S O N T PA N E L O N T PA N E LC K PA N E L O N T PA N E LE a N I N G FA D E R S M O V I N G FA C E P L AT EP L a C I N G T H E C R O S S FA D E R TAT I N G T H E T R a N S F O R M S W I T C H E SP L a C E M E N T PA RT S C H N I C a L S P E C I F I C AT I O N SWA R R a N T Y