Stanton M.303 owner manual Fader Cleaning and Install, Removing a fader

Page 3

FADER CLEANING AND INSTALL

After constant use the faders may need to be cleaned and lubricated from time to time. This will ensure long life and keep a smooth feeling throughout the fader's lifetime. Follow the instructions below to lubricate and clean your faders:

Removing a fader:

1.Make sure mixer is powered off and power supply is disconnected from back of mixer.

2.Remove the fader to be cleaned or replaced by unscrewing the 2 outer screws on the fader plate (removing the 2 inner screws will detach the fader from the fader plate).

3.Disconnect the fader from mixer by removing the connector on the bottom of the fader.

Installing a fader:

1.Once original fader has been removed, simply plug the 4-pin connector into the new fader.

2.Place fader back in mixer and replace 2 outer screws to secure fader.

Image 3
Contents 303 E a S E R E a D C a R E F U L LY B E F O R E U S E Removing a fader Fader Cleaning and InstallDescription of Functions Output level Description of Functions C H N I C a L S P E C I F I C AT I O N S Superior Sound TechnologyP L a C E M E N T PA RT S WA R R a N T Y