Alesis i02 quick start Features, Midi OUT Use a

FEATURES

1.USB PORT – Use the included cable to connect the iO2 EXPRESS to a

computer. iO2 EXPRESS requires a USB 1.1 or higher (e.g. USB 2.0) connection.

2.MAIN OUT – Use standard 1/4" cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the MAIN VOL knob.

3.MIDI IN – Use a

standard five-pin MIDI cable to connect this input to the MIDI OUT of an external MIDI device.

1 2 3 4

	10			10
		9
11	14		11	14
	12	8	12
	13			13
	15 7
19	20 16	6	17	18
		5

4.MIDI OUT – Use a

standard five-pin MIDI cable to connect this output to the MIDI IN of an external MIDI device.

5.PHANTOM POWER LED – Lights up when phantom power is engaged.

6.MIDI OUT LED – Flashes whenever MIDI data is sent out of the iO2 EXPRESS.

7.MIDI IN LED – Flashes whenever MIDI data is received from an external MIDI controller.

8.USB LED – Lights up when a USB connection has been established with your computer.

9.LED METERS – Monitors the audio level of the MAIN OUT.

10.MIC INPUT – Connect a microphone to this input with an XLR

cable.	NOTE: Do not use the MIC INPUT
11. GUITAR / LINE INPUT – Connect a line-level device or guitar	and GUITAR/LINE INPUT at the

to this input with a 1/4" cable.	same time on one channel. This
	may overload the channel and
12. MIC/LINE / GUITAR SWITCH – When this switch is in the
	cause distortion.
"GUITAR" position, the channel will serve as a high-
impedance input for connecting guitar or bass instruments.
When the switch is in the "MIC/LINE" position, the channel will accept mic or line-level signals.

13.GAIN – Adjusts the channel audio pre-fader and pre-EQ gain level.

14.INSERT – The insert jack allows you to insert a compressor, EQ, or any other signal processor in between the iO2 EXPRESS's preamplifier and A/D converter.

15.PHANTOM POWER SWITCH – This switch activates and deactivates phantom power. When activated, phantom power supplies +48V to both XLR mic inputs. Please note that most dynamic microphones do not require phantom power, while most condenser microphones do. Consult your microphone's documentation to find out whether it needs phantom power.

16.MONO / STEREO – Adjusts the headphone mix for mono or stereo operation.

17.MONITOR MIX – Blend in any amount of zero-latency signal from your inputs with the output of your computer.

18.MAIN VOLUME – Adjusts the output volume of the MAIN OUT.

19.HEADPHONES – Connect your 1/4" headphones to this output.

20.HEADPHONE VOLUME – Adjusts the volume level of the headphone output.

3