Aiphone JAW-AZ manual Terminal Definitions, Relay NO, no, Video OUT, Instructions

Page 1

Video Modulator with Audio Door Station and CCTV Interface

- INSTRUCTIONS -

The JAW-AZ converts a standard CCTV camera's signal to a 2-wire signal, compatible with the JA Open Voice Color Video system. This allows the utilization of a color CCTV camera and a separate audio door station (JA-D) to be used in place of a JA video door station (Door 2 input only). Up to two additional CCTV cameras can be connected to the JA Monitor for video only (Adapter 1 & 2 inputs). A motion detector or other activation device can be connected to the Sensor input (in place of JA-D) to trigger the camera. Video output is provided for continual viewing and/or recording. The unit is equipped with a relay output to trigger an external device, such as a DVR or video switcher whenever the audio and/or video to the Aiphone monitor is on.

 

 

 

SENSOR RELAY MASTER

AUDIO

OUT

IN

NC NC NO NO A1 A2

1 2

 

 

 

75 OHM

 

 

VIDEO

 

OFF ON

AIPHONE

 

 

 

 

 

 

 

TERMINAL DEFINITIONS:

 

 

 

AUDIO 1, 2:

JA-D Audio door station input (One per system, Master Door 2 input only)

MASTER A1, A2: Output from JAW-AZ to JA-2M(E)CD master input (A1,A2 or C1,C2)

RELAY NO, NO:

Normally Open relay contact, activated when JA monitor is on

 

SENSOR NC, NC: Normally Closed contact, activates unit when tripped by motion detector or other device

 

with N/C contacts. (Requires “SET” mode to be active on monitor)

VIDEO IN:

Composite input signal from CCTV camera

VIDEO OUT:

Composite output to external CCTV monitor, switcher, DVR, video input on another device

75 OHM SWITCH: Termination Switch. Set to OFF position when VIDEO OUT is connected to CCTV system. Set to ON position when video output is not used

INTERNAL ADJUSTMENT WHEN JA-D AUDIO DOOR STATION IS INCLUDED:

INSTRUCTIONS:

1. Open unit by removing 5 small screws and lifting off cover.

2. Locate Jumper labeled JP1 on the right side of the PC board.

3. Remove the jumper completely, or move it so it is on just one of the posts.

4. Replace the cover and the 5 screws.

Pg. 1

Image 1
Contents Relay NO, no Terminal DefinitionsVideo Video OUTJA-2MECD Wiring DiagramJAW-AZ JA-2HCDOperations Specifications