INSTALLATION INSTRUCTIONS
Figure 2
Unpacking
Remove the LD100/LD100U from the shipping container and examine it for any signs of shipping damage or missing items, (check inventory list on page 5).
All shipping materials should be saved if the unit is to be moved or should need to be returned for service or repair.
Installation
The LD100/LD100U is designed to be placed on the table or rack mounted. If the rack mounting installa- tion kit is to be used, the rack mount ears are installed by removing the 4 screws retaining the wood side panels and installing the rack mount ears using the 3 screws as shown in Figure 2. Remove the four feet from the unit. When installing the LD100 in a rack, it will be necessary to support the LD100/LD100U by using rack support rails supplied by the rack manufacturer.
Do not support the LD100/LD100U by the rack mount ears alone!
Ventilation
The LD100/LD100U will require that air flows freely in both the bottom and top vent holes. Blocking these holes will greatly reduce the reliability of the unit and lead to the possibility of overheating.
When the LD100/LD100U is rack mounted, a mini- mum of 1.25" (1 rack unit height) of free space is to be provided for both the top and bottom of the unit
Figure 3
to allow for proper cooling. It is also recommended that the rack be forced air cooled.
Rear Panel I/O
11. Video Termination Switch – Select ON when
not looping the Video signal to other video devices, (75 Ohm).
12. Video Input (BNC) – Composite Video Input
13. Video Input (RCA) – Composite Video Input
14. Video Input (BNC) – Composite Video Input
Loop
15. Y/C Input (4 Pin) – Y/C, input internally termi- nated.
16.
17.
18.
19. G/Y Termination Switch – Select ON when
not looping the G/Y signal to other video devices, (75 Ohm).
10.G/Y Input Loop (BNC) – Green/Y Input
11.G/Y Input (BNC) – Green/Y Input
12.
13.
14.
8