MC-44S CONCRETE MIXER — ELECTRIC MOTOR
Electric Motor
For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with the electric motor.
Protect the electric motor from dust as much as possible and keep ventilating openings clean.
CAUTION:
■DO NOT spray water at any time on the electric motor.
■DO NOT operate electric motor in a explosive environment.
The electric motor used in this mixer is a
Electric Motor Connection
A 12 inch electrical cable (Figure 2) with a pigtail at one end is provided with the electrical motor for hookup to a power source. Table 1. shows the required NEMA connector for the desired motor horsepower rating. In addition, Table 2 also shows the matching NEMA approved connector for the required extension cord.
ALWAYS, make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.
The electric motor supplied with the mixer is configured from the factoryfor115VACgroundedoperation.Makecertainthatthecorrect size grounded
Motors can burn out when the line voltage falls 10% below the voltage rating of the motor. Failure to use proper voltage will cause the motor to overheat and actuate the overload switch.
If overload protection should actuate because of improper voltage or any other malfunction, turn the main switch on the motor to the "OFF" position and correct the problem, press the reset switch button, and turn the main switch to the "ON" position.
Table 5. Recommended Extension Cord Sizes
Electric | Input | 50 ft. | 75 ft. | 100 ft. | 200 ft. |
Motor | Voltage | (15.24 m) | (22.86 m) | (30.48 m) | (60.96 m) |
|
|
|
|
|
|
1/2 HP | 115 VAC | No. 12 | No. 10 | No. 8 | No. 6 |
|
|
|
|
|
|
Electric MotorVoltage Change Switch
1.ALWAYS make certain the electric motor's ON/OFF switch is in the "OFF" position and the power cord has been disconnected from the power source.
NEVER! disable or disconnect the
NOTE ON/OFF switch on the electric motor. It is provided for operator safety.Injury
may result if it is disable, disconnected or improperly maintained.
PAGE 18