Front Panel Controls and Functions | American Audio Q-MX2 BPM

FRONT PANEL - CONTROLS AND FUNCTIONS

1.FEATHER FADER PLUS™ CROSSFADER - Blends the output signals of any channels assigned to "X" or "Y." When the fader is in the full "X" position, the output signal of any channels assigned to "X" will be controlled by the master volume level. The same fundamentals will apply for "Y." Sliding the fader from one position to another will vary the output signals of the "X" and "Y" channels respectively. When the crossfader is set in the center position, the output signals of both the "X" and "Y" channels will be even.

2.HEADPHONES JACKS - These jacks are used to connect your headphones to the mixer. Use head- phones only rated at 8 ohms to 16 ohms. Most DJ headphones are rated at 16 ohm, these are highly recommended. Two different headphone jacks are conveniently located on the mixer, one on the face and one on the front side panel. Always be sure the Cue Level Volume (6) is set to minimum before you put the headphones on.

3.FADER ASSIGN BUTTONS - These buttons are used to assign a channel to the crossfader. When a channel is assigned to "X," the left side (X-side) of the crossfader will control that channels output level. The "Y" assign works in the same fashion. When a channel is assigned to neither "X" nor "Y" the output volume will only be controlled by the channel's fader level. These button also function as a "TRANS EFFECT" A Trans Effect is an effect similar to cutting the output signal with your transformer switches.