Roland RP-2 manual Adjusting/Replacing the Head, Specifications

Page 11

Adjusting/Replacing the Head

Adjusting the Head Tension

When adjusting, use the included tuning key.

* Striking the pad while the head is loose may damage the sensor. Furthermore, if you use the pad without it being properly adjusted, you could likely experience problems such as the following.

Sometimes it does not sound (uneven volume).

The volume is too low (reduced sensitivity).

fig.01-03

While continuing to check the feel and response, use the tuning key to adjust all eight tuning bolts until the tension is properly adjusted. Always tighten the tuning bolts in the order shown in the figure.

Replacing the Head

The head is an expendable item, whose performance deteriorates with extended use. If the head has torn out or remains slack even after proper adjustment, then replace the head.

Replacement heads (optional)

MH-8 Mesh Head

Replacing the Head

When replacing, use the included tuning key.

1.Remove all tuning bolts and washers.

Go around and gradually loosen each one in order (by turning it counterclockwise).

2.Remove the hoop.

3.Remove the old head.

4.Place the new head on the frame.

5.Place the hoop onto the head.

6.Pass the tuning bolts through the washers, then attach them to the hoop and frame.

7.Tighten all eight tuning bolts until they lightly contact the hoop.

8.Next, adjust the tension of the head. Refer to “Adjusting the Head Tension.”

Specifications

The proper tension is achieved when the feel and response of the head as you strike the pad is about the same as that of an acoustic drum.

Do not tighten any one tuning bolt too firmly all at once. Doing so prevents uniform stretching throughout the head, which is one cause of malfunction.

Head tension may change with extended use of the pad. Make adjustments as needed.

On the V-PRACTICE PAD (RP-2), adjusting the head tension affects only the head response, and does not change the pitch of the sound, as it would on an acoustic drum.

Be careful not to lose the tuning bolts and washers that you removed.

Pad size: 8 inches

Accessories

Trigger: 1 (Head)

Owner's manual, Connection cable

Dimensions

(1 m or 39-3/8 inches), Tuning key

Options

264 (W) x 297 (D) x 60 (H) mm

RHYTHM COACH (RM-2)

10-7/16(W) x 11-3/4 (D) x 2-3/8(H) inches

Pad Stand (PDS-2)

Weight: 890 g or 2 lbs

Mesh Head (MH-8)

Stand screw size: M8

 

962a

*In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice.

5

Image 11
Contents 取扱説明書 安全上のご注意 使用上のご注意 各部の名称 主な特長このパッケージに入っているもの ヘッドの張り具合を調整する ヘッドを調整/交換するお問い合わせの窓口 主な仕様02897712 1*KGS Page Additional Precautions PlacementMaintenance Contents of the Package Names of Components FeaturesSpecifications Adjusting/Replacing the HeadInformation