Onkyo TX-SE550 appendix Video equipment connections, Digital audio connections

Video equipment connections

•On each pair of input jacks, a red connector (marked R) corresponds to the right channel, and a white connector (marked L) to the left channel.

•A yellow connector (marked V) is used for video connection.

•Please refer to the instruction manual of each component when making any con- nections.

Audio connection cable	L
L (Left)
R (Right)	R
Video connection cable
V (Video)	V

DVD Player

AUDIO OUTPUT

VIDEO OUTPUT

DIGITAL COAXIAL OUTPUT

DIGITAL OPTICAL OUTPUT

Digital audio connections

This receiver has a powerful digital signal processor for use with DVD players, DAT decks, and CD players. The digital inputs, DIGITAL-1 and DIGITAL-2, can be assigned to individual input selector buttons, so when an input selector button is pressed, the assigned digital input is used instead of the corresponding analog input. (See page 17.)

		SUB	MULTICHANNEL		FRONT SPEAKERS A			DIGITAL INPUT
		WOOFER	INPUT
ANTENNA		PRE OUT						DIGITAL 2
			R	L
	R	L						(COAXIAL)
			FRONT
	(REC)				L	L	CENTER
AM							SPEAKER
	OUT							DIGITAL 1
	TAPE	MONI-	SURROUND					(OPTICAL)
	(PLAY)	TOR					L	L
		OUT
	IN						SURROUND
FM					R	R	SPEAKERS		AC OUTLETS
75	DVD						R	R	SWITCHED
								REMOTE CONTROL	TOTAL 100W MAX.
	IN
			CENTER	SUB
				WOOFER
	VIDEO-1							10kHz
					FRONT SPEAKERS B
	IN						MODEL NO. TX-SE550	9kHz
GND								AM FREQUENCY
	OUT							STEP
					L	L
L	VIDEO-2

	IN		R	R
R
	R	L	V	220-230V	120V
	PHONO CD			VOLTAGE SELECTOR

AUDIO IN		VIDEO IN
AUDIO OUT		VIDEO OUT
	Video Cassette Recorder

Notes:

VIDEO IN

: signal flow

Monitor TV

•When using a playback-only VCR, you need to make only the output connections.

•This receiver can be used with only a monitor TV equipped with a video input jack.

•Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).

•A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT, VIDEO-2 and AUDIO OUT will not work.

•Remove the protective cap attached to the DIGITAL-1 (OPTICAL) jack before making the connection. When this jack is not used, replace the protective cap.

7