Peavey KB2, KB3 owner manual O N T P a N E L

F R O N T P A N E L

1

2

5 6

3 4 7 8

(1) Level

Controls the 1/4" jack input level on channels 1 and 2 and the 1/4" jack input and XLR input on channel 3.

(2) Low EQ

An active tone control (shelving type: +/-15 dB) that varies the low frequency range.

Caution: Excessive low frequency boost causes greater power consumption and increases the possibility of speaker damage.

(3) Hi EQ

An active tone control (shelving type: ± 15 dB) that varies the hi frequency range.

(4) Mid EQ

An active tone control (peak/notch type: ± 15dB) that varies the mid frequencies. (channel 3)

(5) CH4/Monitor Level

Controls the input level for channel 4. Controls high-impedance microphones or other high-level sources equipped with a 1/4" phone plug.

(6) Headphone Level (KB3 only)

This sets the level to the headphone jack on the rear panel. To avoid damage to your hearing‚ make sure to turn the dial fully counter-clockwise before using headphones. Slowly turn the knob clockwise until a comfortable listening level is set. This does not affect the master level.

(7) Master Level (KB3 only)

This knob sets the overall level for the unit. Make sure the Master level is completely down (full counter- clockwise) before powering up the unit. This does not affect the headphone level.

(8) Power Switch

This two-way rocker switch applies power to the unit when placed in the ON position.

5