Resetting the VGS50
This function erases all of the user presets and restores the VGS50 to the original factory presets.
Caution! This procedure will destroy and reset ALL user presets in the VGS50 memory. Be sure you want to erase the memory and start fresh before continuing with this procedure.
1.Disconnect the power from the rear panel of the VGS50.
2.Press and hold the Low EQ Select button, and the Parameter Select button while reconnecting the power.
The display will briefly show “rS” to indicate that it has reset. After the reset has occurred, the expression pedal needs calibrating and is indicated by the letters “tdn” in the display. Rock the expression pedal forward to the toe down position and press the flashing footswitch 1. The display now reads “tup”. Rock the pedal back to the toe up position and now press the flashing footswitch 3. The expression pedal is now calibrated for use with all programs.
Calibrating the Expression Pedal
If the expression pedal ever has problems with controlling parameters between their full range, it may be necessary to
1.Disconnect the power from the VGS50.
2.Press and hold the Pedal button (12) on the front panel and connect the power.
3.When the display reads “tdn”, release the Pedal button and rock the expression pedal forward to the toe down position.
4.Press the flashing number 1 footswitch. The display now reads “tup”.
5.Rock the pedal back to the toe up position and press the flashing number 3 footswitch.
The expression pedal is now calibrated for use with all programs.
Maintenance and Service
The VGS50 is basically a maintenance free device. There are no user serviceable parts inside of the unit. Opening the chassis will void your warranty. All service and repair must be performed by an authorized DOD service center. Tube replacement should be referred to an authorized service center. Should a problem arise with your VGS50, contact your local DOD dealer for return/repair procedures.
age 16