1.Unscrew the outside FADER PLATE SCREWS (B). Do not touch the INSIDE SCREWS (C).
2.Carefully lift the fader and unplug the CABLE (D).
3.Plug the new fader into the cable and place it back in the mixer.
4.Screw the fader to the mixer.
7.OUTPUT CONTROL SECTION: The level of the AMP OUT (31) is controlled by the MASTER (23) slide. The Master TREBLE (20) and BASS (21) controls allow you to adjust the output of channels 1 - 4. The BOOTH (27) control adjusts the level of the BOOTH OUTPUT (30). HINT: The booth output is used by some DJs to run monitor speakers in their DJ booth. You can also use it as a second ZONE or AMP output.
NOTE: The RECORD OUT (32) has no level control. The level is set by the channel slides of the selected channel.
8.TALKOVER SECTION: The purpose of the talkover section is to allow the program playing to be muted so that the mic can be heard above the music. The MIC/TALKOVER SWITCH (5) controls MIC 1 and MIC 2 and has three settings. When the MIC/TALKOVER SWITCH (5) is in the bottom position, MIC 1 and MIC 2 and talkover are off. When the MIC/TALKOVER SWITCH (5) is in the center position MIC 1 and MIC 2 are on, the MIC INDICATOR (6) will glow, but talkover is off. When the MIC/TALKOVER SWITCH (5) is in the top position, MIC 1 and MIC 2 and talkover will be on and the volume of all sources except the Mic inputs are lowered by 16 dB. The TREBLE (2) and BASS (3) controls allow you to fully adjust the tone of MIC 1 and MIC 2. MIC LEVEL (4) controls the level of MIC 1 and MIC 2.
9.CUE SECTION: By connecting a set of headphones to the HEADPHONE (28) jack, you can monitor any or all of the channels. Press the CUE ASSIGN (18) buttons for channels 1 - 4 to select the channel or channels to be monitored and their respective LED indicators will glow. Use the CUE LEVEL (24) control to adjust the cue volume without effecting the overall mix. By moving the CUE PGM PAN (22) control to the left you will be able to monitor the assigned cue signal. Moving the control to the right will monitor the PGM (program) output. Rotating to the right will monitor the PGM (program) output.
10.DISPLAY: The DISPLAY (19) indicates the MASTER output left and right levels.
Specifications
INPUTS: |
|
DJ Mic | 1.5mV 2kOhm balanced |
Phono | 3mV 47kOhm |
Line | 150 mV 27kOhm |
OUTPUTS: |
|
Amp/Booth | 0 dB 1V 400ohm |
Max | 20V Peak to Peak |
Rec | 225mV 5kOhm |
MIC: |
|
DJ Mic | 1.5mV 2KOhm balanced |
Bass | ± 12dB |
High | ± 12dB |
GENERAL: |
|
Frequency Response | 20Hz - 20KHz +/- 2dB |
Distortion | 0.02% |
S/N Ratio | better than 80dB |
Talkover Attenuation | |
Headphone Impedance | 16ohm |
Power Source | 115/230V 50/60Hz 10W |
Dimensions | 19”w x 4”d x 9”h (483 x 94 x 221 mm) |
Weight | 10.17 lbs (4.6 kg) |
Page 4