Ashly MX-206 manual Specifications

Page - 10 Operator Manual – MX-206 Mixer

Safety Instructions – 3

Introduction - 4

MX-206 Mixer – 5

Connectors & Cables – 5

Physical Description - 6

Installation – 7

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 11

Specifications

SPECIFICATION	MX-206
DISTORTION
THD at +20 dBu, 20Hz-20KHz, input switch at -40dB	<0.05%
IMD (SMPTE) at +20dBu, input switch at -40dB	<0.02%
HUM & NOISE (20Hz-20KHz , input switch at -60dB)
Equivalent input hum and noise	<-127dBu
Residual output noise, TRS outputs, all levels at minimum	<-100dBu
Residual output noise, XLR outputs	<-90dBu
Master Level at nominal, all Ch. Level controls at min	<-84dBu
Master Level and one Ch. Level at nom	<-80dBu
MAXIMUM VOLTAGE GAIN (±2dB)
Mic Input to Master Output, 600 ohm load	<-84dB
Aux In to Master Output	<-34dB
Frequency Response - 20Hz-20Khz	+0/-0.5dB
Crosstalk - between any inputs or outputs 20Hz-20KHz	<-60dB
VU METERS - Two 6-segment LED meters	0VU = +4dBu
PEAK INDICATORS	Peak Clip indicator on each input channel and left and right
	outputs, illuminates 3dB below clipping
	+48 VDC applied to all Mic Inputs, switchable on front panel.
PHANTOM POWER	Maximum total current draw = 80mA.
	Maximum single channel current draw = 14mA.
	Gradual power-up and down to eliminate"pops".
SHIPPING WEIGHT	13 lbs. Maximum
POWER REQUIREMENTS	100-240 Volts, 50-60 Hz, 30 watts

Unless otherwise stated, specification conditions are: 150
source, Input set at "-40", all other controls set at nominal.

Copyright© 2006 – Ashly Audio Inc.