Korg EA-1 manual Creating a song from scratch, Erasing song data Clear Song

	5.Song mode
Creating a song	To playback the completed song from the beginning, press the
	Play/Pause key once, and then press the Stop/Cancel key. Al-
Creating a song from scratch	ternatively, use the cursor keys to make the parameter select
	LEDs indicate Position, and rotate the dial or use the select keys
Here's how to create a song by placing patterns in the desired	to set the position to "001." Then press the Play/Pause key.
order.

If you switch to a different song while editing a song, your edited data will be lost. If you wish to keep the edited song, you must perform the Write operation to save the song data.

Erasing song data (Clear Song)

3,5,6

1,2

1.If the song is playing, press the Stop/Cancel key to stop play- back. Then select the song that you wish to erase.

2.Hold down the Shift key and press step key 16 (Clear Song). (Key 16 will blink.)

3.Press step key 16 once again to erase the song data.

To cancel, press the Stop/Cancel key.

If you erase the song data by mistake, rotate the dial to re-select the song before you save it. This will restore the data to its origi- nal condition.

2 2,3

4,6

If you wish to view the order of patterns in the song, or to re- select the pattern for a specific position, make the parameter select LEDs indicate Pattern. Each time you press a select key, you will move to the next or previous position. You can use the dial to change the pattern number that is displayed.

Use the select keys to move through the positions, and use the dial to select patterns

Pattern

Alternatively, you can make the parameter select LEDs indi- cate Position, and use the dial or select key to select the posi- tion you wish to check. Then make the parameter select LEDs indicate Pattern, and view or change the pattern.

At the Position setting use the select keys or dial to move;

then select Pattern and use the dial to select or view the pattern.

Position

Pattern

mode

Specifying a pattern for each position

Position	001...	256
Pattern	A01...	d64

Specify a pattern for each position. When doing this, please turn the Keyboard function key off (the key will go dark).

1.Use the cursor keys to make the parameter select LEDs indi- cate Position. Notice that the display indicates "001."

2.Use the cursor keys to make the parameter select LEDs indi- cate Pattern.

3.Rotate the dial to select the pattern that you wish to assign to position "001."

4. Press the select [ ] key to advance to the next position. The display will indicate "End."

5.Rotate the dial to select the pattern. The pattern you select here will be the pattern for position "002."

6.When you select a pattern for the "End" position, the "End" will move to the next position. Repeat steps 4 and 5 to assign as many patterns as you wish.

5.Song

35