4 Unit Settings
4.1 Configuring ProBridge Jumpers
The unit ships from the factory with the correct settings for most applications and should not require the installer to open the unit and change the jumper settings. However, for trouble shooting purposes we have included the default jumper settings.
Opening The ProBridge
Place the ProBridge unit face down. Using a small Phillips screwdriver, carefully remove the screws located near each corner of the unit. Once the screws have been removed, lift the cover to detach.
Identifying The Jumpers
With the cover removed, orient the unit as shown here. There are two sets of configurable jumpers. One set, located on the left side of the board, controls how the unit communicates (JP2, JP3, JP4 and JP5). The other set, located at the bottom of the board (P6, twelve pin header) determines specific configuration elements for equipment interfacing.
ProBridge Circuit Board
Philips ProBridge | 10 |