Rear Panel Features, TOP Panel Features

IMPORTANT: Always turn down your volume level(s) to zero before plugging or unplugging your cables from your triggers or the module.

Note: The module's HI-HAT CONTROL TRIGGER INPUT does not support keyboard-style expression pedals.

REAR PANEL FEATURES

1	9	9	9	9	9	9 9	8	7	6	5	4	3

	2

1.POWER SWITCH – Turns the module on and off.

2.POWER IN – Connect the included AC adapter to this input, then connect the adapter to a power source.

3.MAIN OUT – Use 1/4" TS cables to connect these outputs to an amplifier or speaker system. The volume of these outputs is controlled by the MAIN VOL knob on the top panel.

WARNING: Use only the included Alesis power supply with the DM10 module.

4.AUX OUT – Use a 1/4" TS cables to connect these outputs to a monitor system or recording device. The AUX OUT signal can be set to be identical to or independent of the MAIN OUT signal.

5.AUX IN – Connect an external sound source, such as a CD player, to these inputs using a stereo pair of RCA cables.

6.USB – Use a standard USB cable (included) to connect the module to your computer via this USB port. This connection allows the module to send MIDI messages via

USB to an external drum software module. You can also transmit SysEx files over this connection.

7. MIDI IN – Use a standard five-pin MIDI cable to connect this input to the MIDI OUT of an external MIDI device.

8. MIDI OUT – Use a standard five-pin MIDI cable to connect this output to the MIDI IN of an external MIDI device.

9. TRIGGER INPUTS – Connect the triggers of your drum kit to the appropriate inputs here. Please note that dual-zone pads or cymbals (e.g., a drum with head and rim triggers or a cymbal with bow and bell sounds) will require TRS cables to trigger both zones.

TOP PANEL FEATURES

1	2		7		9	10
		6
			8		12
			14 15	16	20	21 22	23
	4	5	17 18	19		24 25	26
		5	17 18	19		24 25	26
			13		11	27
							3

1.MAIN VOLUME – Adjusts the volume level of the MAIN OUT.

2.HEADPHONES VOLUME – Adjusts the volume level of the HEADPHONES OUTPUT on the module's front panel. The HEADPHONES VOLUME is independent of the module's MAIN VOLUME.

3.HEADPHONES OUTPUT – Connect your 1/4" headphones to this output. You can adjust the volume of this output with the HEADPHONES volume knob on the module's top panel.

4.MIXER – Slide these faders to adjust the levels for the different groups of drum sounds. Each fader controls a drum sound in each bank. The current bank (A or B) is determined by the MIX BANK button.