Hotpoint GX 751 F G K, GX 751 F G X, GX 641 F G X, GX 641 F G K Electrical connection

Page 6

!Use the hooks contained in the “accessory pack”.

GB

•Where the hob is not installed over a built-in oven, a wooden panel must be installed as insulation. This must be placed at a minimum distance of 20 mm from the lower part of the hob.

Ventilation

To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams).

.

45

mm.

mm

 

560

 

 

!The hob can only be installed above built-in ovens with a cooling ventilation system.

Electrical connection

!The supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents. Should you require it, you may use a longer cable, however, you must ensure that the cable supplied with the appliance is replaced by one of the same specifications in accordance with current standards and legislation.

or:

•the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13

amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

!The wires in the mains lead are coloured in accordance with the following code:

Green & Yellow - Earth

Blue- Neutral

Brown - Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

Your appliance is supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

!THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re-fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Replacement fuse covers

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

Removing the plug

If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc., please ensure that either:

•the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval.

How to connect an alternative plug

The wires in this mains lead are coloured in accordance with the following code:

BLUE

“NEUTRAL” (“N”)

BROWN

“LIVE” (“L”)

GREEN AND YELLOW “EARTH” (“E”)

 

 

 

GREEN &

 

 

YELLOW

 

 

BROWN

13 amp fuse

 

 

 

BLUE

CROSS-BAR

 

 

CORD GRIP

 

 

 

 

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Operating Instructions GX 641 F G GX 641 F G K GX 751 F G GX 751 F G KDo not touch the appliance surface Assistance CommunicatingDescription of the appliance Overall viewInstallation PositioningElectrical connection Gas connection Connection with a rigid pipe copper or steelChecking the tightness of the connection GB Burner and nozzle specifications General safety Precautions and tipsPractical advice on using the burners Start-up and useCleaning the appliance Maintenance and careSwitching the appliance off DisposalTo clean the Ftgh burner 40CTroubleshooting Gas tap maintenancePage Page Parts and Accessories After Sales ServiceHotpoint Service Essential Contact InformationGB Guarantee

GX 641 F G K, GX 751 F G X, GX 751 F G K, GX 641 F G X specifications

Hotpoint is well-known for producing a wide range of appliances, and their gas cookers, particularly the GX 641 F G X, GX 751 F G K, GX 751 F G X, and GX 641 F G K models, are designed to offer both versatility and convenience in the kitchen. These cookers are engineered to enhance home cooking experiences while providing innovative features and technologies.

The Hotpoint GX 641 F G X is a 60cm gas cooker that combines style with functionality. It features four gas burners, allowing for multiple cooking tasks simultaneously. The enamel pan supports provide durability and stability, ensuring pots and pans stay securely in place. One of the standout features is the integrated grill, which allows for healthier cooking options through grilling, perfect for preparing meat, veggies, or toast. Additionally, this model includes a large oven capacity, which provides ample space for roasting and baking.

Moving on to the Hotpoint GX 751 F G K, this model stands out with its extensive cooking options. It features five gas burners, including a powerful wok burner suited for high-heat cooking. This flexibility makes it easy to prepare a variety of dishes, from quick stir-fries to slow-cooked casseroles. The oven is also equipped with a fan assist, promoting even heat distribution for perfectly baked goods. The oven cavity features a durable enamel coating, making it easier to clean after cooking.

The GX 751 F G X is another impressive model in this range. It shares many features with the GX 751 F G K but boasts a sleek stainless-steel finish that adds a modern look to any kitchen space. This model is designed with safety in mind, featuring a flame failure device that automatically cuts off gas supply if the flame goes out, ensuring peace of mind while cooking.

Finally, the Hotpoint GX 641 F G K shares similar features to the GX 641 F G X but includes an easy-to-use control panel that ensures precision when adjusting temperatures. Its compact design is ideal for smaller kitchens without sacrificing functionality. All four models emphasize user-friendly controls and easy maintenance, making them excellent choices for both novice cooks and culinary enthusiasts alike.

Overall, the Hotpoint GX series gas cookers offer a blend of practical features, modern technology, and stylish designs, making them perfect for elevating everyday cooking experiences.
Top Page Image Contents