Instructions for Remote Operation

Plug in your electric fireplace, and turn on the Main Power On/Off switch on the right side of the front panel. It will beep once. This means you have power and your remote is ready to operate your electric fireplace.

1.ON/OFF: Press this button to turn on the power.

2.FLAME: Press this button to turn on the flame effect. Keep pressing down this button, the flame/log light will turn from bright to dim. Pressing this button again will turn off the flame.

3.750W Button: Press this button and the fireplace will work at 750W. Pressing again will switch it off.

4.1500W Button: Press this button and the fireplace will work at 1500W. Pressing again will switch it off.

INSTRUCTIONS FOR POWER

This heater is for use on 120 volts only. The cord has a plug as shown at (A) in the following figure. An adapter as shown at (C) is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do not only turn off heater from the main “ON/OFF” switch, be sure to unplug this heater

-6 -