Vermont Casting A052041 Assembly Instructions Assemble Base to Pillar, Use hardware bag a

Assembly Instructions • Assemble Base to Pillar

tools needed:

3⁄8" open-end wrench

7⁄16" open-end wrench

Locate this part:

	top
	back
	base
	( 1 )
	shown
	right-
front	side up
locking
casters

assembled

pillar and bottom casting

Use hardware bag “A”:

1/4-20 x 3/4”

( 6 )

1/4-20 ( 6 )

1.Lock the pre-assembled casters on base by pushing down on the latch.

2.Set the base upside-down on onto the pillar bottom as shown on the adjacent page, aligning holes in base with holes in pillar.

3.Insert six bolts through the holes in the pillar and base. Thread the locking hex nuts onto bolts. Tighten with a wrench and a flat- head screwdriver.

4.Locate the two black lead wires inside the grill bottom. Press the metal contacts of the loose ends of the lead wires onto the metal pins located on the base and side of the ignitor unit.

back

14