Viking VGIQ410-3RT/E1*, VGIQ412-2RT1*, VGBQ410-3RE1* manual Utility

OUTDOOR—C OOKING

41”W. Ultra -Pre mium T-Series/E -Se ries Gas Grill

Installation Requirements

VGBQ410-3RE1*	VGBQ412-2RE1*	VGIQ410-3RT/E1*	VGIQ412-2RT1*
T-Series/E-Series	T-Series/E-Series	T-Series /E-Series	T-Series Two-Burner Grill
Three-Burner All-Grill	Two-Burner Grill	Three-Burner All-Grill	w/Side Burners
	w/Side Burners	(inc. TruSear™ Burner)	(inc. TruSear™ Burner)
		UTILITY

REQUIREMENTS

GAS

Fixed piping installations

•Check with local gas utility company or with local codes for instructions on installing gas supply lines. All gas connections should be made by a competent technician and in accordance with local codes and or ordinances. In the absence of codes, the installation must comply with the National Fuel Gas Code ANSI Z223.1.

•An installer-supplied gas shut- off valve must be installed in an easily accessible location. All installer-supplied parts must conform to local codes.

•Must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of that system at test pressures equal to or less than 1/2 psi (3.5 kPa).

Natural gas models

•Water column pressure

o Operating pressure—4.0"

WCP

o Supply pressure of 6" – 14"

WCP

o If incoming pressure exceeds 14" WCP,a step-down regulator is required.

•Accepts standard residential 1/2” (1.3 cm) ID gas service line; 1/2” (1.3 cm) NPT male with 7/8” (2.2 cm) flare adapter. o If using a Viking GSH12

flexible hose, remove the 1/2” (1.3 cm) flare adapter and attach hose to the 7/8” (2.2 cm) male flare on the regulator assembly.

LP/propane models

•Water column pressure

o Operating pressure—10” WCP o Supply pressure of 11” – 14”

WCP (for fixed piping installations)

o If incoming pressure exceeds 14” WCP,a step-down regulator is required.

•Accepts standard residential 1/2” (1.3 cm) ID gas service line; 1/2” (1.3 cm) NPT male with 3/8” (0.95) flare adapter.

LP/propane tank installations

•Water column pressure

o Operating pressure—10”

WCP

•Includes high-capacity hose/regulator assembly for connection to a standard 5- gal./20-lb. (approx. 12” diameter/18”H.) LP/propane gas cylinder equipped with a Type 1, QCC-1 connector

o The cylinder connection device must be compatible with the Type 1, QCC-1 connector on the outdoor cooking appliance.

o The cylinder must be provided with a shut-off valve terminating in an LP/propane gas supply cylinder valve outlet specified.

o The cylinder supply system must be arranged for vapor withdrawal and provided with a listed OPD (overfilling prevention device).

ELECTRICAL

•T-Series models

o 9-volt DC battery for electronic ignition

o 2’ (61.0 cm) power cord supply cord with 3-prong grounded plug attached to rotisserie motor.

•120 VAC/60 Hz

o Rotisserie motor max. amp usage—6.0

•E-Series models

o 3’ (91.4 cm) power cord supply cord with 3-prong grounded plug attached to grill

•120 VAC/60 Hz

o 120 VAC/60 Hz

o Grill max. amp usage

•VGBQ/VGIQ410—2.2

•VGBQ/VGIQ412—2.3 o 2’ (61.0 cm) power cord

supply cord with 3-prong grounded plug attached to rotisserie motor.

•120 VAC/60 Hz

o Rotisserie motor max. amp usage—6.0

PLUMBING

Not applicable

	VGBQ410-3RE1	VGBQ412-2RE1	VGIQ410-3RT/E1	VGIQ412-2RT1
Burner rating
Standard SS grill burners (each)	25,000 BTU (7.3 kW) Nat./22,500 BTU (6.5 kW) LP (T-Series)
	29,000 BTU (7.3 kW) Nat./28,000 BTU (6.5 kW) LP (E-Series)
Smoker burner (split standard)		12,500 BTU (3.7 kW) Nat./10,500 BTU (3.1 kW) LP
GourmetGlo™ rotisserie burner		15,000 BTU (4.4 kW) Nat./13,500 BTU (4.0 kW) LP
Side grill burners (each)		15,000 BTU (4.4 kW) Nat./13,500 BTU (4.0 kW) LP
TruSear infrared burner	30,000 BTU (8.8 kW) Nat./LP		30,000 BTU (8.8 kW) Nat./LP

PLANNING AND DESIGN GUIDE

RE LE A S E D 8/ 5 /0 8

VI KIN GRA NGE .COM • 1 -888 -V IK ING 1 © 2 0 0 8 V R C — INFORMATION SUBJECT TO CHANGE