Masterbuilt Complete Guide on How to Light a Grill and Operating the Stainless Steel Pedestal Model

Page 5
CAUTION: Opening lid
with caution during use. Grill is very hot and will release heat.

BURNER LIGHTING INSTRUCTIONS

1.Read all instructions and warnings before lighting

2.Check the gas control valve and gas cylinder valve to be certain it is in the OFF position before connecting to the gas cylinder. perform soapy water test before each use.

3.Open lid during lighting

4.Turn gas control valve on, turn gas cylinder valve on

5.Push down knob and turn to 'ignite' and light

6.Repeat up to three time if necessary

7.If ignition does not take place immediately, wait five minutes and then match light. See match light instructions below.

8.After each use, first turn the gas control valve off first, then the gas cylinder valve off. Always allow grill to cool completely before touching, moving, or storing.

CAUTION: Fatty foods (like hamburgers) can have excess grease and can cause flair up. When cooking fatty foods, use a low setting with lid open.

NOTE: Burner ring must be screwed down full length of threads to fall through recessed area of burner ring. This will allow the burner ring to sit flat on the burner. Failure to do this will cause a lazy flame.

MATCH LIGHTING INSTRUCTIONS

1.Read all instructions and warnings before lighting

2.Check the gas control valve and gas cylinder valve to be certain it is in the OFF position before connecting to the gas cylinder. perform soapy water test before each use.

3.Open lid during lighting

4.Turn gas control valve on, turn gas cylinder valve on

5.Push down knob and turn to low setting

6.Place a lit fireplace match through lighting hole in back of grill.

7. After each use, first turn the gas control valve off first, then the gas cylinder off. Always allow grill to cool completely before touching, moving, or storing.

6

GRILL ASSEMBLY, BREAK DOWN & PARTS LIST

The Masterbuilt Stainless Steel Pedestal Grill is fully assembled at time of purchase.

BURNER RING CHECK

 

BEFORE LIGHTING

 

GRILL, CHECK BURNER

 

RING TO MAKE SURE IT IS

 

FIRMLY IN PLACE & FLAT

 

ON TOP OF CAST

 

BURNER BEFORE

 

LIGHTING. IF THE

 

BURNER RING IS NOT IN

 

PLACE PROPERLY, THE

 

BURNER WILL NOT BURN

 

CORRECTLY, PRODUCING

 

A LOW FLAME.

3

Image 5
Contents Grill is HOT while in use and after do not touch Never operate this grill unattendedCut LineTRY Southern Secrets Grilling RecipesSafe Storage & Maintenance Gas Cylinder Placement and FillingMatch Lighting Instructions Grill ASSEMBLY, Break Down & Parts ListBurner Lighting Instructions Before each use perform soapy Water test. Before each use GAS Control Valve Operations