Assembly Instructions, Wheel Leg Assembly

ASSEMBLY INSTRUCTIONS

To reduce the risk of a cut, pinch, or other bodily injury:

•Wear protective gloves when handling or assembling parts that could have sharp edges.

STEP 1. Front Leg Assembly

Install Leg Caps (13) on ends of Front Leg (2) (FIG. 1).

Note: The Front Leg does not have holes at the end near the Leg Caps

STEP 2. Wheel Leg Assembly

Lay the Wheel Leg (3) on its side on a hard floor or surface. Insert Wheel Axle Rivet (16) through outer recessed hub of Wheel (6) and through Wheel Leg (FIG. 2). Place Wood Anvil (14) under center of Wheel Axle Rivet and Wheel hub. Drive the Axle Pushnut (15) (FIG. 3) onto Wheel Axle Rivet. Repeat for the other side of Wheel Leg.

Note: The Wheel Leg (3) has holes at the end of the tubes, and is shorter than Front Leg (2).

Axle Pushnut
Wheel Leg
Wheel
recessed hub of Wheel
Wheel Axle Rivet
Wood Anvil	FIG. 2

FIG. 1

Wheel Leg

Front Leg

No holes Leg Cap at bottom

FIG. 3

STEP 3. Slide Vent Assembly

Insert 10-24x1/2” Bolt (22) through the slot in the Slide Vent (9) and through the hole in the Bowl (4). Attach a Square Nut

(20)to the Bolt but do not tighten completely (FIG. 4). Attach Bolt (22) and Square Nut (20) on the other end of the Slide Vent to the Bowl.

Repeat for the second Slide Vent on the opposite side of the Bowl. Square Nuts should be on the inside of the Bowl. Note: Tighten Bolts and Square Nuts but make sure Slide Vents move easily from side-to-side.

STEP 4. Rear Grid Bracket Assembly

With the hinge holes in bowl toward the back, align bottom dimple and upper hole of Rear Grid Bracket (10) with holes inside Bowl (4) in the bowl back. Insert #8 Screw (21) through the upper hole of Bowl and Rear Grid Bracket (FIG 4 and FIG. 5). Tighten screw into bracket. Repeat for second Rear Grid Bracket

Note: Rear Grid Brackets have one hole and one indented dimple each.

STEP 5. Bowl Handle and Front Grid Bracket Assembly

Align two holes in the Front Grid Bracket (11) with the holes inside the Bowl (4) in the bowl front (FIG 4). Align the Bowl Handle (7) with the same two holes. Insert #10-16 x 5/8” Screw (19) through the top hole of the Front Grid Bracket, through the Bowl, and into the top hole of the Bowl Handle. Do not tight completely. Insert a second screw into the bottom hole of the Front Grid Bracket, through the bottom hole of the Bowl and into the bottom hole of the Bowl Handle. Do not tighten. Repeat for second Front Grid Bracket to mount the Bowl Handle and both front brackets. Tighten completely, but do not over tighten or cross-thread.

Note: Front Grid Brackets have two holes in each.

Bowl Back

Front Grid

Bracket

Bowl

Align hinge

Handle

holes to the

back.

FIG. 4

Slide Vent

Bowl Front

Rear Grid Brackets

3/8 Screw

Hole

Indented dimple

FIG. 5