MAINTENANCE
ALWAYS COVER FUEL INLET WITH DUST CAP TO PREVENT
OBSTRUCTION FROM DEBRIS OR SPIDER WEBS WHEN NOT IN USE.
A WORD ABOUT STAINLESS STEEL
Stainless steel exposed to high heat for prolonged periods will change in color and texture. The radiant plates and other internal parts, used to distribute heat evenly across the grill, do so by deflecting high heat over a large surface area. This pro- longed exposure to high temperature will cause the plates to change color. This “bluing” and later “browning” is normal and will not affect the product operation.
Exterior Stainless Steel Components
We recommend that you clean grill after each use. Use soapy water with a soft cloth or sponge. Rinse with fresh water and dry. We also recommend that you cover the grill between uses. Optional covers are available from your retailer or directly from Magma.
Interior Stainless Steel Components
We recommend cleaning after each use. Oven/Grill Cleaner is recommended to remove
Igniter Electrode
The igniter electrode, located just beside the burner, should be kept clean of all grease and debris. Wipe it clean with a soft cloth. Care should be taken not to damage the ceramic insulation, spark electrode or bend the electrode wire during this process.
Grill Grates
We recommend that you clean the grill grates with a brass wire brush while the grill is warm. They can then be washed by hand as required. Oven/Grill Cleaner is recommended to remove
Control Valves
The valves were adjusted, set, and tested at the factory. You should not attempt to adjust the valves. Call MAGMA if you suspect that your valve is not properly adjust- ed.
Removal and Cleaning the Burner Tubes
1. Lift burner out | 2. Rotate burner. | 3. Lift and pull. | 4. Remove. |
of bracket. |
|
|
|
•Inspect burners, remove debris or spider webs.
•Inspect valve oriface while burner is removed, clean if needed.
•To
in burner tube. | 6 |
|