GRILL ASSEMBLY
Install Heat Indicator
1.Insert heat indicator probe through the hole in the grill body lid. Slide on 5/32” ID x 9/16” OD washer and press on 5/32 ID push nut to secure. Use a 1/4” socket to push on the push nut.
Figure 12
Reinstall Grill Body Top to Grill Body Bottom
1.Secure the grill body top to the grill body bottom by replacing the two hinge pins and clips. See Figure 13.
Charcoal Frame and Grates
1.Place the charcoal grate frame in the lower grill body bottom on the lower casting ledge front and back. See Figure 14.
2.Set the charcoal grates into place in the bottom of the char- coal grate frame. See Figure 14.
Figure 14
3.Set the cooking grids in place.
Ash Pan
1.Open the lower access door and slide the ash pan into place and close and latch the door. See Figure 15.
REAR OF GRILL
Figure 13
Install Shelving
1.If your grill has side shelves they should be installed at this time. See shelving installation instructions that came with the
shelving accessory. Note: Remove and discard plugs on side | Figure 15 | |
of the grill where the side shelf will be installed. | ||
|
Page 12 |