Char-Broil 463621611 manual Piezo PUSH-BUTTON and Rotary

Page 25

Troubleshooting (continued)

Problem

Possible Cause

Prevention/Solution

 

 

 

Burner(s) will not light

PIEZO PUSH-BUTTON AND ROTARY:

•Replace ignitor.

using ignitor.

•Push-button sticks at bottom.

 

•Rotary knob rotates without clicking.

•Replace knob.

 

•Sparking between ignitor and electrode.

•Inspect wire insulation and proper connection. Replace wires if

 

 

insulation is broken.

 

 

 

Burner(s) will not

•See “GAS ISSUES:” on previous page.

 

match light.

•Match will not reach.

•Use long-stem match (fireplace match).

 

 

•Improper method of match-lighting.

•See “Match-Lighting” section of Use and Care.

 

 

 

Low flame, drop in gas

•Out of gas.

•Check for gas in LP cylinder.

flow.

•Excess flow valve tripped.

•Turn off control and tank knobs, wait 30 seconds, turn tank knob on

 

 

 

slowly, light grill. If flames are still low, turn off control and tank

 

 

knobs and disconnect regulator. Reconnect regulator, turn tank knob

 

 

on slowly, light grill.

 

•Vapor lock at coupling nut/LP cylinder

•Turn off control and tank knobs and disconnect regulator. Reconnect

 

connection.

regulator, turn on tank knob slowly, light grill.

 

 

 

Flames blow out.

•High or gusting winds.

•Turn front of grill to face wind or increase flame height.

 

•Low on LP gas.

•Refill LP cylinder.

 

•Excess flow valve tripped.

•Refer to “Sudden drop in gas flow” above.

 

 

 

Flare-up.

•Grease buildup.

•Clean burners and inside of grill/firebox.

 

•Excessive fat in meat.

•Trim fat from meat before grilling.

 

•Excessive cooking temperature.

•Adjust (lower) temperature accordingly.

 

 

 

Persistent grease fire.

•Grease trapped by food buildup around

•Turn knobs to OFF. Turn gas off at LP cylinder. Leave lid in position

 

burner system.

and let fire burn out. After grill cools, remove and clean all parts.

 

 

 

Flashback...

•Burner and/or burner tubes are blocked.

•Turn knobs to OFF. Clean burner and/or burner tubes. See burner

(fire in burner tube(s)).

 

cleaning section of Use and Care.

 

 

 

Unable to fill LP

•Some dealers have older fill nozzles

•The worn nozzles don’t have enough “bite” to engage the valve. Try

cylinder.

with worn threads.

a second LP dealer.

 

 

 

25

Image 25
Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsFirst Time Use TemperatureLava Rock / Briquettes Pre-Heating Your GrillDirect Cooking Food SafetyIndirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures General Cleaning Why Clean?Routine Care Storing Your GrillLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling UseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderAll Parts Year from date of purchase Limited WarrantyKey Qty Description Parts ListParts Diagram Cone side of wheel against leg AssemblyWheels Side braces Tank exclusion wireShelves Firebox assemblyVaporizer Bar Lid assemblySwing Away Cooking GrateTank Retainer Grease Cup and Grease Cup ClipRegulator LP Tank Tank Retainer Emergencies Possible Cause Prevention/Solution TroubleshootingPiezo PUSH-BUTTON and Rotary Page Warranty Registration Department Box Columbus, GA