Logo Plate

Attach two Spacers and Lid Handle to Grill Lid using two 1/4-20x2 ½”Machine Screws, Insulated Washers, and 1/4-20 Flange Nuts.

Lid Handle

Insulated Washer

Spacer

Install Temperature Gauge by placing the stem through the large hole in front of the Grill Lid. Attach the nut provided until snug against the Lid.

Temperature Gauge

Insert Vent Knobs into side of Grid Lid from the outside. Inside the Grill Lid, slide a Vent Plate onto the Knob stud followed by a Vent Spring and a #10-24 Hex Nut.

Tighten just enough to allow Vent to slide freely from side to side.

Repeat for other side.

Vent Knob

Vent Plate

Vent Spring

Attach the Logo Plate by inserting the two pins into the small holes on the front of the Grill Lid.

From the inside of the Lid, press the Logo Plate Clips onto the pins until they are snug against the Lid.

Page 10