Outdoor Built-in Cooktop, 27 41-7/8 | GE ZGG420LBPSS instruction

ZGG420NBPSS - Natural Gas Built-in Outdoor Grill ZGG420LBPSS - LP Gas Built-in Outdoor Grill

Dimensions and Installation Information (in inches)

12" Min. to Combustibles 4" Min. Clearance for Lid to Non-Combustibles

27"41-7/8"

10-1/4" from

Bottom of

Support Flange

*25-1/2"

Countertop Depth

27" to Front

of Control Panel

28-1/2" to Front of Bullnose

	Outdoor Built-in Cooktop
	These grills are designed to be installed into a non-
	combustible enclousure.
	• The grill drops into the opening and hangs from
	the side flanges. It does not require support from
	the bottom.

26"	• The cutout must be completely covered with
	non-combustible material such as stone, brick,
	ceramic tile, concrete board, etc. The countertop
	surface and edges must be flat and level.
	• If the countertop has an overhang, it must be
	notched or cut back flush with the front face of
	the cabinet below.
	• Allow at least 12" minimum clearance at the
	back of the grill when the exhaust is directed to a
	window or surface that is difficult to clean. Allow
	at least 4" clearance behind the grill to allow the
	hood lid to open. See notched detail below.
	• Allow 12" minimum clearance on both sides
	and the back of the grill to adjacent vertical
	combustible construction.
	• These gas grills cannot be used below any type of
	overhead construction.
	• These grills are designed for outdoor use only. Do
	not locate the cooktop in a building, garage or
	other enclosed or semi-enclosed area.
	• Locate the backside of the grill away from
	prevailing winds and avoid cooking in windy
	conditions.

*The weight of the grill is fully supported by the side trims. The back of the grill overlaps the back edge of the cutout.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

40-3/4"

Gas and

Electrical

Locations

24-1/2"

Specification Created 10/08

170132