Frigidaire 27 manual Gas Requirements, GAS Installation, Tank Information, Tank USE

Page 8

Gas Requirements

L.P. GAS INSTALLATION

Sonoma Gas Grills are set to operate with L.P. gas and come with a high capacity hose and regulator assembly. (Note:

Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Sonoma). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. L.P. Cylinders are not included with the grill. L.P. Cylinders can be purchased separately at an independent dealer.

LP hose/ regulator supplied (Type 1 connector)

L.P. TANK INFORMATION

Never use a dented or rusted L.P. tank or cylinder with a damaged valve.

L.P. cylinders are equipped with an O.P.D (Overfilling Prevention Device). The device shuts off the flow of gas to a cylin- der after 80% capacity is reached. This limits the potential for release of gas when the cylinder is heated, averting a fire or possible injury.

The L.P. cylinder must have a shut-off valve terminating in an L.P. gas supply cylinder outlet specified, as applicable, for connection No. 510 in the standard for compressed gas cylinder valve outlet and inlet connection ANSI/CGA-V-1. Cylinders must not be stored in a building, garage, or any other enclosed area. (The L.P. cylinder must have an overfill protection device, OPD, on it.)

The L.P. gas supply cylinder must be constructed and marked in accordance with the specifications for L.P. gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CAS-B339, “Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.”

L.P. TANK USE

When turning the L.P. tank on, make sure to open the valve SLOWLY two (2) complete turns to insure proper gas flow. Most gas tanks now come equipped with a leak detector mechanism internal to the tank, when gas is allowed to escape rapidly it shuts off the gas supply. Opening the valve rapidly may simulate a gas leak, causing the safety device to activate, restricting gas flow causing low flames. Opening the valve slowly will insure this safety feature is not falsely triggered.

When not in use, gas supply cylinder valve is to be in the “OFF” position.

The tank supply system must be stored upright to allow for vapor withdrawal.

The regulator and hose assembly must be inspected before each use of the grill. If there is excessive abrasion or wear or if the hose is cut, it must be replaced prior to the grill being used again.

Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area.

Only a qualified gas supplier should refill the L.P. tank.

Do not store a spare L.P. gas cylinder under or near the grill.

6

Image 8
Contents N o m aTM Page General Safety Instructions Important Safety InformationGrill Features SGR27LP Side Burner Parts Assembly Grill AssemblyLeft Shelf Assembly Grill Assembly Igniter Assembly Interior Parts AssemblyGAS Installation Gas RequirementsTank Information Tank USEPre Operation Leak Testing Before TestingTesting General InformationGrill Burner Lighting Lighting the GrillBefore Lighting Using the Grill Grill LocationGeneral Rules Do not leave the grill unattended while cookingMatch Lighting Using the Side BurnerSide Burner Lighting Care and Maintenance Igniter Access Under Side Burner ShelfDrip Tray Cooking GratesTroubleshooting Your Grill General Trouble ShootingBefore Calling Customer Service Problem SolutionGrill will not light with a match or low heat with dial set To High positionFlame is erratic Flare-upsWarranty Limited Lifetime Warranty