TANK RETAINING BRACKET
1.Fasten the bracket to the bottom of the propane bottle using bolt and nut supplied. (Fig. 1)
2.Tighten the lag screw into the mounting surface leaving approximately 1/4” of thread above the surface.
3.Slide propane bottle into position so that the bracket slides under the head of the lag screw. (Fig. 2)
4.Tighten the lag screw onto the bracket.
5.For fastening to a concrete surface a concrete anchor will be required. (Not Supplied)
Fig. 1
E TH | RU |
SE |
Fig. 2
FINISHING
LOG PLACEMENT / AGGREGATE
BASE
LOG
1.Set base log onto burner ensuring stud and bracket fit into hole and notch. Base log should sit fl at on "Patiofl ame" base.
#1
2.Place "Y" end of log #1 into "Y" notch on the base log.
7
#2
3. Place pocket on log #2 onto the locator on the base log.
#3
4.Hook log #3 into notch on base log.
#4
5.Place log #4 into notch on base and pocket on log #3.
AGGREGATE
6.Patiofl ame is supplied with 3lbs of lava rock. All 3lbs can be poured into outer ring. It may be mixed, or layered with desired aggregate on top.
DO NOT PLACE AGGREGATE ONTO BURNER.