®
Assembly and Instruction Sheet
Dome Fireplace
Model 5055-710
Follow these instructions for assembly and read carefully, particularly the safety statements. The safety alert symbol, 
is a universally recognized symbol used to identify safety information about hazards that can result in personal injury. When this symbol is used you should pay very close attention to what is written. Review these instructions before beginning assembly or using your fireplace.
FOLLOW INSTRUCTIONS AND WARNINGS TO AVOID FIRE,
SERIOUS INJURY OR DEATH.
WARNING
•Outdoor use only. Never use in enclosed area. Use in unventilated areas will endanger your life.
•Keep away from all combustible materials including gasoline and other flammable liquids and vapors.
•Use on a level, noncombustible surface only. Keep away from house, garage, balconies, or eave overhangs.
•Keep out of the reach of children.
•Be sure screen is in place while in use and do not use in windy conditions.
•Do not overfill firebowl or use to burn leaves and trash.
•Exercise the same care you would with an open fire.
•Never leave unit unattended when hot or in use.
•Completely extinguish fire before leaving.
•Use gloves when handling or moving. Ashes can remain warm for a long time after extinguishing.
•Dispose of cold ashes properly.
•Do not modify in any way nor use with parts not expressly approved by Coleman.
•Combustion
Contact local authorities regarding possible burn restrictions before using product.
Fireplace Parts Check List
|
| • Check package for all parts needed for assembly. |
| |||
■ | 1. | Firebowl | ■ | 7. | Leg Support Ring |
|
■ | 2. | 4 Pc. Screen Assembly | ■ | 8. | Screen Support Rings (2) | |
■ | 3. | Handle | ■ | 9. | Hardware Kit |
|
■ | 4. | Dome Lid | ■ 10. | Leg Assemblies |
| |
■ | 5. | Protective Cover | ■ 11. | Grates |
| |
■ | 6. | Top Ring |
|
|
|
|
|
|
|
|
|
|
|
| 1 | 2 | 3 |
| 4 | 5 |
|
|
| ||||
11
6
9 | 8 |
7 |
10
•Check all items for shipping damage. Call Coleman at
Assembly
1. Carefully unpack all parts from shipping box.
NOTE: In Steps 2 and 3, the stand is assembled up side down for ease of assembly. Use a ground cloth to protect the finish.
2. Align holes in Leg Assembly Brackets with holes in Top Ring. Attach with two small screws per leg. Hand tighten.
Top
Ring
(Large)
Assembly (cont.)
3a. Assemble Leg Support Ring to the four leg assemblies. Fasten to Leg Brackets with one small screw per leg (see arrows). Tighten all fasteners.
3b. Install four foot pads, one into each leg.
NOTE: In some models, the foot pads are
4a. To assemble screen, align holes in the 3 screen panels with the holes on outside edge of screen support ring. Attach with small screws and hex nuts but do not tighten at this time.
NOTE: Make sure latch bracket panel and hinge panel are positioned as shown for proper installation.
Latch Bracket pointing up
Hinge Panel 