Char-Broil 42804468, 10101550 manual Fig. a

ASSEMBLY

Tools required for assembly:

Phillips Screwdriver (Not Supplied); Small Adjustable Wrench (Not Supplied)

1

•Carefully turn the unit upside down.

•Slide Heatshield into place over the exposed burner tube.

Align hole in Heat Shield with end of Burner Tube

Heat Shield in Position

	•	While holding the Heat Shield in place, slide the Control Panel Assembly into place, taking care to ensure that
2
		the valve engages the burner tube. shown Figure A

•Install two #10x3/8" self-tap screws through the right side of the control panel. Leave screws loose.

•Make sure valve is inside burner tube. Align the heat shield as shown Figure B.

Secure control panel using the two remaining #10x3/8” self-tap screws. Tighten all four screws.

Qty: 4

#10x3/8" Self-Tap Screw

Fig. A

Burner Valve

Tube End

Proper Valve to Burner Tube installation

(veiw from underneath control panel)

Screw hole	Fig. B
for leg - used
later.

Heat shield

Control

Panel

Carefully insert valve end into burner tube making sure valve is centered with burner tube, after aligned correctly, loosely secure with two self-tap screws on RH side of control panel.

Hold Heat Shield in place while attaching Control Panel

Screw hole for leg - used later.

Ignitor Wire

NOTE:

Ensure that the valve engages the burner tube

NOTE:

Install these screws first!

Page 13