Char-Broil 466270611 manual Temperature gauge stem

Page 15

		Pull out the two knobs from control panel. Insert temperature gauge stem into the bigger hole above knob bezel, shown A.
	5
	5	Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, shown B/C.
		Re-install the two knobs.	Temperature gauge stem

Temperature gauge

Control panel

Knob bezel

Knob

A

B

Back of the panel

C

		Attach right side fascia to right side shelf using two #10-24x3/8”screws, 5mm lock washers and 5mm flat washers.
	6
		Only right side shelf shown for assembly, install left side shelf with fascia in the same way.

5mm flat washer

5mm lock washer #10-24x3/8” screw

Right side shelf

Right side fascia

15

Image 15

Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsUSE and Care LP Liquefied Petroleum GasLP Cylinder Filling For your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Leak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valveItems Manufacturer will not PAY for Limited WarrantyKey Qty Description Parts ListParts Diagram Front AssemblyUpper back panel Temperature gauge stem Foldable side shelf Right side shelf Back of main control panel Grease tray opening Left rail Right rail Wire Flame tamers Grease tray Cylinder screw at rear of cart Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Warranty Registration Department Box Columbus, GA