Char-Broil 466250511 manual Nut

11 Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition Module.Total (4) connections.

Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections, shown A.

Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with the nut, shown B.

Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.

NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).

A

(a) 1 2 3

B

Nut

	side	panel
Left

Electronic ignition module

4

(b)

C

+ -

Cap AA battery

12

Inside of cart, insert rear tabs(w/o holes) of tank heat shield into slots on the bottom of upper back panel. Attach front tabs(w/holes) of tank heat shield under front brace using two #8x3/8” self-tapping screws.

Front brace

Tank heat shield

#8x3/8” self-tapping screw

20