Troubleshooting - Electronic Ignition
Problem (Ignition) | Possible Cause | Check Procedure | Prevention/Solution |
|
|
|
|
SECTION I | • Battery not installed | • Check battery orientation. | • Install battery (make sure that “+” and |
No sparks appear at | |||
any electrodes when | properly. |
| connectors are oriented correctly, with “+” end up |
ignition button is |
|
| and |
pushed; no noise can | • Dead battery. | • Has battery been used | • Replace battery with new |
be heard from spark | |||
module. |
| previously? |
|
| • Button assembly not | • Check to insure threads are | • Unscrew button cap assembly and reinstall, making |
| installed properly. | properly engaged. Button | sure threads are aligned and engaged fully. |
|
| should travel up and down |
|
|
| without binding. |
|
| • Faulty spark module. | • If no sparks are generated | • Replace spark module assembly. |
|
| with new battery and good |
|
|
| wire connections, module is |
|
|
| faulty. |
|
|
|
|
|
SECTION II | • Output lead | • Are output connections on | • Remove and reconnect all output connections at |
No sparks appear at | |||
any electrodes when | connections not | and tight? | module and electrodes. |
ignition switch is | connected. |
|
|
pushed; noise can be |
|
|
|
heard from spark |
|
|
|
module. |
|
|
|
|
|
|
|
SECTION III | • Output lead | • Are output connections on | • Remove and reconnect all output connections at |
Sparks are present | |||
but not at all | connections not | and tight? | module and electrodes. |
electrodes and/or not | connected. |
|
|
at full strength | • Arcing to grill away | • If possible, observe grill in | • If sparks are observed other than from burner(s), |
| |||
| from burner(s). | dark location. Operate | wire insulation may be damaged. Replace wires. |
|
| ignition system and look for |
|
|
| arcing between output wires |
|
|
| and grill frame. |
|
| • Weak battery. | • All sparks present but weak | • Replace battery with a new |
|
| or at slow rate. |
|
| • Electrodes are wet. | • Has moisture accumulated | • Use paper towel to remove moisture. |
|
| on electrode and/or in burner |
|
|
| ports? |
|
| • Electrodes cracked or | • Inspect electrodes for | • Replace cracked or broken electrodes. |
| broken “sparks at | cracks. |
|
| crack”. |
|
|
|
|
|
|
Certified Grill Parts And Accessories®,
Artisan Collection by
Protected under one or more of the following U.S. Patents: 4,598,692; 4,624,240; 4,747,391; 4,747,391; 4,817,583; 4,924,846; 4,989,579; 5,003,960; 5,076,256; 5,076,257; 5,090,398; 5,109,834; 5,224,676; 5,277,106; 5,421,319; 5,441,226; 5,452,707; 5,458,309; 5,566,606; 5,566,606; 5,579,755; 5,582,094; 5,613,486; 5,649,475; 5,706,797; 5,711,663; 5,765,543; 5,931,149; 5,996,573; 6,095,132; 6,135,104; 6,173,644B1; 6,279,566; 6,397,731; 6,418,923; 6,439,222; 6,523,461; D282,619; D339,714; D341,292; D343,337; D358,059; D361,466; D364,535; D372,637; D373,701; D377,735; D383,035; D397,910; D405,643; D405,643; D406,005; D406,009; D413,043; D413,229; D413,229; D414,982; D415,388; D416,164; D416,441; D416,441; D417,587; D422,516; D423,274; D423,876; D428,303; D435,396; D436,004; D438,059; D438,060; D438,427; D439,110; D442,505; D443,179; D443,354; D447,384; D447,385; D447,909; D448,610; D448,614; D448,615; D448,616; D448,975; D449,492; D451,759; D456,202S; D460,313, D461,359 and D504,048. Canada: 87743; 87744; 92607; 92608 and 1,316,424. Other Patents Pending. Assembly instructions © 2006.
26 • 463268008