Char-Broil 463270911 manual Holes on fascia to Attach valve bracket

8

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to

attach valve bracket

Screws and Washers removed from valve bracket

Install bezel with “OFF” at top.

Sideburner fascia

Sideburner valve bracket

24

Valve stem

Note: Use upper and lower

holes on fascia to

attach bezel

Control knob #8-32x3/8” screw

4mm

lock washer

Control knob bezel

9	Pull out the three knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown A.
	Make the temperature gauge attached on the panel. Push the temperature gauge downward till it clips on the panel,

shown B/C. Re-install the three knobs. Temperature gauge stem

Temperature gauge

Knob bezel

Control panel

Knob

A

B

Back of the panel

C

17