Coleman 9993 manual Lighting Instructions, Lighting the Burners, Match Lighting

Lighting Instructions

WARNING

THE FOLLOWING RULES MUST ALWAYS BE FOLLOWED IN THIS ORDER (Fig. 44):

1.OPEN THE GRILL LID! Any attempt to light the grill with the lid down could cause an explosion.

2.Check that the burner control knobs are turned to “OFF”.

3.Turn on the fuel supply. For an L.P. gas cylinder,

turn the top cylinder valve knob counterclockwise one rotation to open.

4.DO NOT stand with your head or arms over the grill.

Fig. 44

3

4

1

2

Fig. 45

	Igniter Switch
Burner Knobs

Lighting the Burners

1.Push and turn one of the main burner control knobs counterclockwise to the “HIGH” position. Wait 5 seconds (Fig. 45 and 46).

2.Push and hold the igniter button until burner lights. You will hear a snapping sound (Fig. 47).

3.If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes for the gas to clear before trying again.

4.Repeat steps 1 through 3 to light the remaining burners.

5.If the burner does not light on the second try, turn the control knob to OFF and wait 5 minutes for the gas to clear, and then try match-lighting the burner.

Fig. 46 Fig. 47

Match Lighting

1.Strike and place the burning long wooden match (or butane lighter with extension) through the spaces in the grill grates near the ports of the burner between the heat tents (Fig. 48).

2.Push and turn the control knob counterclockwise to the “HIGH” position.

3.Repeat steps 1 and 2 to light the remaining burners.

CAUTION

Use a LONG wooden match or a butane lighter with an extension. Make sure all burner controls are off except for the burner being lighted. If a long-reach match or lighter is not accessible, use the match extension. The match extension is located inside the doors. Insert a match in the holder end of the extension, strike and place the burning match near the BURNER being operated.

Fig. 48

14