
troubleshooting
Although the manufacturer has attempted to ensure that your grill will operate properly and satisfactorily, some- times problems do arise. The following troubleshooting guide lists several possible problems and their probable cause and solution.
| Problem | Cause | Solution | 
| Burner will not light. | Gas injector not inserted in venturi | Realign/engage gas injector with the | 
| 
 | tube. | venturi tube. | 
| 
 | Clogged gas injector. | Remove gas injector from gas control | 
| 
 | 
 | assembly and clean. | 
| 
 | Obstruction in gas line. | For propane models, ensure gas valve | 
| 
 | 
 | on cylinder is OFF. Remove flexible | 
| 
 | 
 | hose and blow out any debris. | 
| 
 | Spider webs in venturi tubes. | Clean venturi tubes. See Maintenance | 
| 
 | 
 | Section. | 
| 
 | Misalignment of collector box and | Position electrode properly. Clean col- | 
| 
 | burner. | lector box. | 
| 
 | Out of gas | Refill LP gas cylinder. If natural model, | 
| 
 | 
 | turn on gas at source. | 
| 
 | Dead battery. | Replace with AA Alkaline battery. | 
| Inadequate grill tempera- | Poor combustion. | Adjust air shutter. | 
| ture. | Misalignment of venturi tube and gas | Realign/engage gas injector with the | 
| 
 | injector. | venturi tube. | 
| 
 | Inadequate gas pressure. | Contact gas supplier for assistance. | 
| 
 | Incorrect orifice/valve setting. | Refer to gas conversion instructions in | 
| 
 | 
 | this manual. | 
| Flames blow out. | Cold grill. | Preheat grill at least 5 minutes on HI | 
| 
 | 
 | with the grill lid closed. | 
| 
 | Misalignment of burner tube and gas | Realign/engage gas injector with the | 
| 
 | injector. | burner tube. | 
| 
 | Poor combustion. | Adjust air shutter. | 
| 
 | Extreme wind. | Turn or shield grill. | 
| Yellow flames. | Air shutter improperly set. | Open air shutter | 
| 
 | Spider webs in venturi tubes. | Clean venturi tubes. See Maintenance | 
| 
 | 
 | Section. | 
| 
 | Seasoning salts on burner. | Clean by washing burner with mild | 
| 
 | 
 | detergent. | 
| 
 | Oil film on burner. | Allow burner to operate on HI for 10- | 
| 
 | 
 | 15 minutes. | 
| Page 22 |