Install control panel and burner control knobs You will need: control panel, two Phillips screws/ washers, a Phillips screwdriver, and burner control knobs.
1)Set the control panel in place over both frame braces. Hold the Crossover Ignition button up while setting the control panel in place.
2)While looking under the right trim piece push the control panel down and line up the holes in the control panel with the white plastic plugs in the frame brace. Insert screws and tighten with a phillips screw driver until snug. Do not over tighten.
3)Push each of the burner control knobs onto their valve.
(1)
(2)
(3)