Side Burner Troubleshooting
Problem | Check | Cure |
Side Burner does not light. | Is gas supply off? | Turn supply on. |
|
|
|
Flame is low in HIGH position. | Is the fuel hose bent or kinked? | Straighten hose. |
|
|
|
Flame is very yellow in | Inspect the Weber® Insect / Spider | Clean Weber® Insect / Spider |
conjunction with the smell of gas, | screen for possible obstructions. | screen (See section “Annual |
| (lockage of holes.) | Maintenance”) |
OR |
|
|
Burner makes popping noise in |
|
|
conjunction with the smell of gas. |
|
|
|
|
|
Push button ignition does not | Does burner light with a match? | If match lights burner, checkigniter |
work. |
| (see below). |
|
|
|
Side Burner maintenance
WARNING: All gas controls and supply valves should be in the OFF position.
Check igniter: Remove side burner cover. To remove side burner cover, remove control knob and screws that hold cover to bottom(1).
(1) |
|
| (2) |
| ||
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(3)
Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight.
Note: If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. Adjust igniter electrode to burner. Gap should be 1/8 to 3/16 inch from tip of electrode to burner. Spark should be a white/blue color, not yellow.
1)Igniter
2)Igniter Wire
3)Venturi/Burner
4)1/8 to 3/16 inch gap between electrode and burner
(4)