Put the control panel back on, Install glass doors

Step 15

Put the control panel back on

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Place your thumbs over the control panel push-in buttons, and push them into the frame brace until they snap into place. Figure 25 (a).

Push on the burner control knobs. Figure 25 (b).

(a)	(b)
	Figure 25

Pull the right hand swing table up. Stand to the right side of the barbecue. Slightly pull back both side burner locks. Slide the side burner toward the control panel. The locks will snap into the slots in the front and back of the side burner. Figure 26.

mCaution: Make sure both locks have snapped into place.

View from top

Side view

Figure 26

Step 16

Install glass doors

You will need: one LH glass door assembly and two RH glass door assemblies.

Start with the LH door assembly. Insert the long hinge pin at the top of the door into the plastic bushing in the underside of the left frame. Insert the bottom (short) hinge pin into the bushing in the frame connector. Repeat the procedure with the RH door assemblies. The glass doors latch on the frame connector. Figure 27.

Bushing in underside and long hinge pin

Bushing in frame connector and short hinge pin

Bushing in the underside

Figure 27