Weber 42092 manual Lighting, To Extinguish

Page 36

Operating Instructions

Lighting

1)

Open the lid.

Summary lighting instructions are on the control panel.

2) Make sure all burner control knobs are turned OFF.

 

 

(Push control knob down and turn clockwise to ensure

DANGER

 

that it is in the OFF position.)

Failure to open the lid while igniting the barbecue’s

 

WARNING: The burner control knobs must be in the

burners, or not waiting 5 minutes to allow the gas to

 

OFF position before turning on the liquid propane

clear if the barbecue does not light, may result in an

 

cylinder tank valve. If they are not in the OFF

explosive flame-up which can cause serious bodily

 

position, when you turn on the LP cylinder valve,

injury or death.

 

the “excess gas flow control” feature will activate,

 

 

limiting the flow of gas from the LP cylinder. If this

Crossover® Ignition System

 

should occur, turn OFF the LP cylinder valve and

Note - The Crossover® ignition system ignites the set of left

 

burner control knobs. Then start over.

burners with a spark from the igniter electrode inside the

 

DANGER:

Gas Catcher™ ignition chamber. You generate the energy

 

for the spark by pushing the electronic ignition button.

When the “excess gas flow control” feature is

WARNING: Check hose before each use of

activated, a small amount of gas is still flowing to the

barbecue for nicks, cracking, abrasions or cuts. If

burners. After turning OFF the cylinder knobs, wait at

the hose is found to be damaged in any way, do not

least 5 minutes for the gas to clear before attempting

use the barbecue. Replace using only Weber®

to light the barbecue. Failure to do so may result in an

authorized replacement hose. Contact the

explosive flame-up, which can cause serious bodily

Customer Service Representative in your region

injury or death.

using the contact information sheet provided with

3) Turn the cylinder on by turning the cylinder valve

your manual.

 

counterclockwise.

 

 

 

 

WARNING: Do not lean over the open barbecue.

 

4) Select the burner set you want to operate.

1

5) Push LEFT burner control knob down and turn to

 

START/HI in selected burner set.

 

 

 

6) Push igniter button and hold until burner ignites. You

4,5,8

 

will hear the igniter sparking.

7) Check that the burner is lit by looking through the

 

 

 

cooking grates. You should see a flame.

 

 

WARNING: If the burner does not light, turn the

7

 

LEFT burner control knob to OFF and wait 5

 

minutes to let the gas clear before you try again or

 

 

 

 

try to light with a match.

 

8) After the LEFT burner is lit you can turn on the RIGHT

2

 

burner adjacent to it. The RIGHT burner lights from the

 

LEFT burner.

6

To Extinguish

3

Push down and turn each burner control knob

2

clockwise to the OFF position. Turn gas supply OFF at

*The grill illustrated may have slight differences than the

the source.

model purchased.

 

D-3

Image 36
Contents M M I T LP Gas Grill Owners GuideLiquid Propane GAS Units only Contents Warranty Customer Service Center Roselle Road, Suite Schaumburg, ILGeneral Instructions Storage and/or NonuseCleaning Grilling MethodsExploded View Exploded View List Parts List Parts List Ba401.c Only start these bolts Do not tighten yet Page Page Remove packing tape holding Page Page Matchlight Holder Page Page B406LP.c Page Page Page Page Page Connecting the Liquid Propane Gas InstructionsImportant LP Cylinder Information CylinderConnection. Using a wrench could damage Regulator coupling and could cause a leakTo Connect the hose to the cylinder Gas grill have been factory tesated. We do however Check for gas leaks Gas Refilling the Liquid Propane Cylinder Liquid Propane Cylinder Checking the fuel level in your tankSafe handling tips for Liquid Propane Gas CylindersFor Canada Only Operating Instructions Grilling MethodsFlavorizer system D406LP.d Direct cookingGrilling Tips & Helpful Hints Indirect cookingLighting To ExtinguishWhen you turn on the LP cylinder valve, the excess Manual LightingThey are in the off position Cylinder valve. If they are not in the OFF positionSide Burner Lighting Instructions Lighting only the side burnerUsing the Smoker Lighting the Smoker Burner Manually Lighting the Smoker Burner Main & Smoker Burner Troubleshooting Problem Check CureSide Burner Troubleshooting Push button ignition does not workMaintenance Annual MaintenanceMain Burner Cleaning Procedure Weber Spider /Insect screensReplacing Main Burners Positioned properly over Crossover Ignition System Operations