Step 20
Install Lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 26.
Hair pin cotter
Hinge pin
Figure 26
Step 21
Add tool holders, control panel and burner control knobs
You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.
Hook the tool holders over the frame rail. Figure 27.
Set the control panel in place over both frame braces. Hold the Crossover Ignition button up while setting the control panel in place. Line up the holes in the control panel with the holes in the inserts in the frame brace.
Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 27 (a).
Push on the three burner control knobs. Figure 27 (b).
Insert in
frame brace
(a)
Crossover
Ignition
Button
Control panel
Phillips screws/
washers
(b)
Tool holders
Figure 27
20