Weber 43720 Connection. Using a wrench could damage, Regulator coupling and could cause a leak

Gas Instructions

We utilize various LP tank manufacturers. Some of the	Note: This connection tightens clockwise and will not allow
tanks have differing top collar assembles. (The top collar	gas to flow unless the connection is tight. The connection
is the metal protective ring around the valve.) One series	requires tightening by hand only.
of tanks mount with the valve facing front. The other tanks	WARNING: Do not use a wrench to tighten the
mount with the valve facing away from the fuel scale.	connection. Using a wrench could damage the
These types of tanks are illustrated below.	regulator coupling and could cause a leak.
You will need: LP cylinder, a soap and water solution and a	5) Mix soap and water.
rag or brush to apply it.	6) Turn on the cylinder valve.
1) Turn the LP cylinder so the opening of the valve is
either to the front, side or rear of the Weber® gas
barbecue. Lift and hook the cylinder onto the fuel
gauge.

	7) Check for leaks by wetting the fitting with the soap and
	water solution and watching for bubbles. If bubbles
	form, or if a bubble grows, there is a leak.
	If there is a leak, turn off the gas and tighten the fitting. Turn
	the gas back on and recheck with the soap and water
2) Loosen the cylinder lock wing nut. Swing the cylinder	solution.
	If leak does not stop, Contact the Customer Service
lock down. Tighten the wing nut.
	Representative in your region using the contact information
	sheet provided with your manual. Do not use the barbecue.
	8) When leak checking is complete, turn gas supply OFF
	at the source and rinse connections with water.

To Connect the hose to the cylinder:

3)Remove the plastic dust cover from the valve.

4)Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only.

C-2