Burner Mixer Tube | Brinkmann OUTDOOR GAS COOKER specification

Burner
Mixer Tube	Burner Assembly
	Burner Assembly
Burner Mixer
Tube Head

Brass

Extension Air Opening Hitch Pin

Tube

Lava Rocks

15" Lava Rock Grate

Square Nuts

10-24 x w"

Screw

10-24 x 12"

Screw

STEP 5:

a.Turn burner assembly over in base pan. Insert the end of brass extension tube (that extends inside the base pan) into the head of burner mixer tube.

b.Position burner assembly in center of base pan and push tab on bottom of burner bracket through slot in bottom of base pan.

c.Install the hitch pin through the hole in the tab on the underside of base pan. This will hold the burner assembly in place.

IMPORTANT: The burner mixer tube head must remain sleeved over the brass extension tube. Visually inspect the installation by looking into the air opening on the side of the burner mixer tube head. When properly installed, the end of the brass extension tube can be seen inside the mixer tube.

NOTE: The air opening in the mixer tube head must not be obstructed in any manner. Check periodically and clean grease and other substances from burner mixer tube head to allow proper airflow.

STEP 6:

a.Insert a 10-24 x 12" screw in each of the three lower holes on side of base pan directly above each leg. Secure screws using square nuts on the inside of base pan. These screws will hold the 15" lava rock grate.

b.Insert a 10-24 x w" screw in each of the three holes located near the top edge of base pan directly above the screws for the lava rock grate. Secure screws using square nuts on the inside of base pan.

c.Place the 15" lava rock grate inside of base pan on the three 10-24 x 12" screws (lower level).

d.Place an even layer of lava rocks over entire surface of grate. Position rocks closely together so there are no large gaps between rocks.

NOTE: To convert this unit to a gas grill, simply place a 152" chrome cooking grill on top of the 10-24 x w" screws.