Brinkmann Smoker Operating Instructions, Remove dome lid and smoker body from base pan

Page 7

OPERATING INSTRUCTIONS

PLACE THE SMOKER OUTDOORS ON A HARD, LEVEL, NON-COMBUSTIBLE SURFACE

AWAY FROM ROOF OVERHANG OR ANY COMBUSTIBLE MATERIAL. NEVER USE ON WOODEN OR OTHER SUR- FACES THAT COULD BURN. PLACE THE SMOKER AWAY FROM OPEN WINDOWS OR DOORS TO PREVENT SMOKE FROM ENTERING YOUR HOUSE. IN WINDY WEATHER, PLACE THE SMOKER IN AN OUTDOOR AREA THAT IS PRO- TECTED FROM THE WIND.

READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY

BEFORE OPERATING YOUR SMOKER.

CAUTION: Before each use, check handles and support brackets to make sure they are securely fastened.

1.Remove dome lid and smoker body from base pan.

2.Always use high quality charcoal. If using a Charcoal Chimney Starter, follow all manufacturer’s warnings and instructions regarding the use of their product. Carefully place 10-15 pounds of hot coals in the char- coal pan. Proceed to Step 5.

If using charcoal lighting fluid, follow all manufacturer’s warnings and instructions regarding the use of their product. Use charcoal lighting fluid approved for lighting charcoal ONLY. Do not use gasoline, kerosene or alcohol for lighting charcoal. Place 10-15 pounds of high quality charcoal in charcoal pan.

3.Saturate charcoal with lighting fluid and wait 2 to 3 minutes for fluid to soak in. Store charcoal lighting fluid safely away from smoker.

4.Carefully light the charcoal and allow to burn until covered with a light ash (approximately 20 minutes) prior to closing door and placing dome lid on smoker. This will allow charcoal lighting fluid to burn off.

WARNING: Failure to do this could trap fumes from charcoal lighting fluid in smoker and may result in a flash-fire or explosion when door is opened or dome lid is removed.

5.Refer to “Flavoring Wood” section of this manual for the recommend- ed amount of flavoring wood. Use long cooking tongs to carefully place flavoring wood on top of hot charcoal.

NOTE:

Depending on the weather, a full pan of charcoal will burn for

 

5-6 hours.

6.Place empty water pan inside smoker body on the lower support brackets. Position water pan so rim is resting securely on notched out step of all three support brackets.

7.Place the smoker body on base pan, making sure the water pan is still in place.

8.Carefully, fill water pan with warm water or marinade to 1" below the rim. A full pan holds 5-6 quarts of water and will last for approximately 3-4 hours. Do not overfill or allow water to overflow from water pan.

9.Place a cooking grill on the lower support brackets directly above the water pan.

10.Place food on the cooking grill in a single layer with space between each piece. This will allow smoke and moist heat to circulate evenly around all pieces.

Smoking

1"

6

Image 7
Contents Assembly and Operating Instructions Important Safety Warnings Properly dispose of all packaging material Parts List Assembly InstructionsStep Step Remove dome lid and smoker body from base pan Operating InstructionsGrilling & Searing Flavoring Wood Option 2 Adding Water Through the Side Door Option 1 Adding Water Through TOP of SmokerProper Care Maintenance AFTER-USE SafetyONE Year Limited Warranty