WARNING
Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.
WARNING
LIGHTING INSTRUCTIONS:
Follow the instructions exactly.
1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.
2.Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.
3.Turn on the fuel supply by rotating the cylinder valve knob
4.DO NOT stand with head, body, or arms over the grill when lighting.
LIGHTING THE MAIN BURNERS:
1.Open lid before lighting burner.
2.Make sure all control knobs are in the "OFF" position.
3. Select the burner to be lit. Push and turn the control knob of that burner to the "HIGH" position.
4. Press the electronic igniter and hold for 3 – 5 seconds to light burner.
5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6. Repeat steps 3 – 5 for lighting each burner. Always use electronic igniter for lighting each burner. If burner does not ignite using the
7.To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the cylinder.
NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
MATCH LIGHTING THE MAIN BURNERS:
1.Open lid before lighting.
2.Turn the burner control knobs to "OFF".
3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to approximately 1/2" (1 to 2 cm) from the burner.
4.Turn on the FAR LEFT burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.
Lighting Hole
Matchlighter |
6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the "HIGH" position.
7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.
10