Brinkmann ProSeries 6418 owner manual Trouble Shooting

Page 18

TROUBLE SHOOTING

Problem:

Burner will not light

Fire at control knob

Yellow Flames at burner

Flame blows out on "LOW"

Burner does not get hot enough

Grill is Too Hot

Possible Causes:

1.Check LP cylinder fuel level.

2.Bad electrode spark.

Check to see if the grill will match light. Electrode or collector may need adjustment.

3.Burner may not be properly seated.

4.Burner may be obstructed.

5.The cylinder valve may be closed.

6.Regulator is not properly seated on cylinder valve.

1.Burner holes may be obstructed. See section on "Burner Assembly/Maintenance" under Proper Care and Maintenance.

2.Burner is improperly seated on control valve.

3.Gas connections may be loose.

Leak Check and tighten all connections.

1.Burner is obstructed. See section on

"Burner Assembly/Maintenance" under Proper Care and Maintenance.

1.Burner holes may be obstructed. See section on "Burner Assembly/Maintenance" under Proper Care and Maintenance.

2.Grill is not sufficiently preheated.

3.Burner is improperly seated on control valve.

1.Flow control device has been activated in regulator. See Regulator Resetting Procedure under Connecting LP Cylinder and Hose/Regulator to Grill.

1.Excess grease build-up causing grease fires.

2.Damaged or faulty regulator.

Replace with factory authorized parts.

3.Cook on a lower temperature setting.

17

Image 18
Contents Heavy-Duty Gas Grill Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorLeak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Side Burner Match Lighting the Side BurnerTurning OFF the Grill Preheating the Grill Operating the GrillBreaking in Your Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerCleanliness Grilling to Proper TemperatureHelpful Hints Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCETransporting and Storage Cooking GrillsHeat Distribution Plates Before Storing Your GrillTrouble Shooting Frequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions For Missing PARTS, Please Call Customer Service AT Step Locking Caster Hex Nut Wrench Spring Pin Door Pivot Grease Cup Bracket Alignment M6 X 12mm round head bolt Burner Venturi Side Burner Grate Place warming rack in slots above cooking grills ProSeries 6418 Assembled Accessories Page Page Warranty