![](/images/new-backgrounds/1256405/25640529x1.webp)
How to inhale with the OMRON MicroAIR U22
!Caution: Only use type and amount of medications as prescribed
and instructed by your doctor.
Medication
1. Slightly tilt the unit as illustrated in the figure. In this position, the vibrator is immersed in the medication and nebulisation will start after power on.
After the vibrator has been immersed in the medication, |
|
|
the unit can be used under any angle. |
|
|
!Caution: In some positions (e.g. upright), nebulisation may |
| Vibrator |
stop after a short while. In that case, briefly tilt the unit again |
| |
in order to |
|
|
2. Place the mouthpiece in your mouth or place the mask over |
|
|
mouth and nose. |
|
|
Always be calm and relaxed when you inhale. Breathe in slowly and |
|
|
deeply so that the medication can reach deep in to the bronchial |
|
|
tubes. Hold your breath briefly, then breathe out slowly while |
|
|
removing the mouthpiece from your mouth. Do not breathe too |
|
|
quickly. Pause when you feel like having a rest. |
|
|
You may synchronise the nebulisation with your inhalation/exhalation |
|
|
cycles by using the unit in ‘manual nebulisation mode’. Refer to page |
|
|
14. |
|
|
Note: |
| |
If | Air Port | |
If excessive medication collects on the mesh, nebulisation may |
|
|
stop. In that case, turn off the power and remove the mask adapter. |
|
|
Absorb the medication by means of a |
|
|
!Caution: Do not poke the mesh with a cotton swap or a pin; the |
|
|
mesh may be permanently damaged. |
|
|
After inhalation always switch off the nebuliser by pressing the (/ I) button.
When an AC adapter was used, disconnect the AC from the electrical outlet.
15