Batteries and charging
Off Board Battery Charger
Your scooter is supplied with an
1.Switch your scooter off at the tiller power switch.
2.Remove the battery pack from the scooter (if required).
3.Connect charger to the charging socket on the battery pack.
4.Ensure that the charger plug is dry and intact before connecting it to the mains and switching it on.
5.A reset button is located on the battery pack to the
Important safety warnings:
Do not expose any part of the battery pack to direct heat (i.e. naked flame, gas fire).
Do not allow the batteries to freeze.
When charging always place on a hard surface in a room with good ventilation. You should not charge your batteries in outdoor conditions.
Always use recommended batteries from your local authorised agent. The
In all cases, the charger must only be repaired by an authorised agent.
Fuses
There is a reset button on the
There is also a fuse fitted in the mains plug of the battery charger, if this blows, switch off at the mains and replace the blown fuse with a new fuse of the same value.
28 | Iss 1 |
|
|