Pride Mobility XL-8 Motor Brushes, CONSOLE, CHARGER, and Rear Electronics, Fuse Replacement

Page 36

X . C A R E A N D M A I N T E N A N C E

MOTOR BRUSHES

The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodically for wear by your authorised Pride Dealer.

CONSOLE, CHARGER, AND REAR ELECTRONICS

Keep these areas free of moisture, and allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.

FUSE REPLACEMENT

In the event a fuse should cease to work:

!Remove the fuse by pulling it out of its slot.

!Examine the fuse to be sure it is blown. See figures 25 and 26.

!Insert a new fuse of the proper rating.

WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure to use properly rated fuses may cause damage to the electrical system and may result in personal injury.

LIGHT BULB REPLACEMENT

The scooter’s light bulbs are easily replaceable. Do not use regular automotive-type 12-volt light bulbs; your scooter is equipped with a 24-volt electrical system. Replacement light bulbs can be purchased from your authorised Pride Dealer.

Figure 25. Working Fuse

Figure 26. Blown Fuse (Replace)

NOTE: Use only 24-volt light bulbs.

!Remove the light cover.

!Gently remove the bulb by pulling it straight out.

!Insert a new bulb of the same wattage.

!Replace the light cover.

STORING YOUR SCOOTER

If you plan on not using your scooter for an extended period of time, it is best to:

!Fully charge its batteries prior to storage.

!Disconnect the batteries from the scooter.

!Store your scooter in a warm, dry environment.

!Avoid storing your scooter where it will be exposed to temperature extremes.

WARNING! Always protect batteries from freezing temperatures and never charge a frozen battery. This damages the battery and can cause personal injury.

For prolonged storage, you may wish to place several boards under the frame of your scooter to raise it off of the ground. This takes the weight off the tyres and reduces the possibility of flat spots developing on the areas of the tyres contacting the ground.

36

www.pridemobility.com

Legend Classic XL-8

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Ultimate In Style & Performance F E T Y G U I D E L I N E S N T E N T S IIISafety N T R O D U C T I O NPURCHASER’S Agreement Information ExchangeProduct Safety Symbols S a F E T YS a F E T Y Removable Parts Pre-Ride Safety Check ModificationsWeight Limitations Tyre InflationIncline Information Maximum Recommended Incline Angles Cornering Information Braking InformationOutdoor Driving Surfaces Stationary Obstacles Steps, Kerbs, etcPublic Streets and Roadways Inclement Weather Precautions Freewheel ModeStairs and Escalators DoorsBattery Disposal and Recycling LiftsLift/Elevation Products BatteriesMotor Vehicle Transport Getting Onto and Off of Your ScooterReaching and Bending Positioning BeltsPrescription Drugs/Physical Limitations AlcoholElectromagnetic and Radio Frequency Interference EMI/RFI I . Specification S 10 cm 33 cmSpecifications Y O U R S C O O T E R Tiller ConsoleHi-Low Switch Class 3 Only Lights SwitchSpeed Adjustment Dial Horn ButtonTiller Console Fuses Handbrake Lever Not ShownRear Section Anti-Tip WheelsMain Circuit Breaker Reset Button Motor/Transaxle Assembly Not ShownManual Freewheel Lever Reading Your Battery Voltage A T T E R I E S a N DCharging Your Batteries Follow these easy steps to charge your batteries safelyFrequently Asked Questions Faqs A T T E R I E S a N D C H a R G I N GWhat type and size of battery should I use? To change a battery in your scooterBattery Disposal and Recycling How can I get maximum range or distance per charge?Why do my new batteries seem weak? What about public transportation?PRE-RIDE Adjustments and Checks O P E R a T I O NBefore Getting on Your Scooter Getting Onto Your ScooterPower Down Timer Feature Getting OFF of Your ScooterComfort Adjustments Tiller Angle AdjustmentFront-to-Back Seat Adjustment I . C O M F O R T a D J U S T M E N T SSeatback Adjustment To adjust the reclining seatArmrest Angle Adjustment Seat Height AdjustmentPower Seat Optional To operate the power seatDisassembly I I . D I S a S S E M B L Y a N D a S S E M B L YTo disassemble your scooter Assembly To release the toggle latchTo separate the frames B a S I C Troubleshooting Diagnostic Flash CodesWhat if all the systems on my scooter seem to be dead? What if the main circuit breaker repeatedly trips? A R E a N D M a I N T E N a N C E Fuse Replacement Light Bulb ReplacementMotor Brushes CONSOLE, CHARGER, and Rear ElectronicsW a R R a N T Y T E S INFMANU2367
Top Page Image Contents